How to Change the Bracelet on Your Wryst Watch
Swapping the bracelet on your Wryst watch is a simple but precise task. Whether you're switching to a new strap for style or comfort, this guide will walk you through the process step by step.
What You’ll Need
-
Two screwdrivers, size 1.5 mm
-
A clean, flat surface to work on (preferably light-colored)
-
Patience and attention to detail
Step-by-Step Instructions
1. Prepare Your Tools and Workspace
Place your watch face-up on a clean table. Make sure the surface is tidy and well-lit. You will be handling small parts that are easy to lose.
2. Unscrew the Bracelet Bar
-
Insert one screwdriver into each side of the bracelet screw.
-
Hold both sides firmly and begin turning anti-clockwise.
-
One side will slowly loosen and come out—this is the short screw.
Tip: Be ready to catch the short screw as it comes out. It’s tiny and easy to misplace.
3. Remove the Bar and Decorative Rings
-
Once the short screw is out, gently push down the bar from the same side.
-
As the bar slides out, two small decorative rings will fall—one from each side.
You should now have:
1 short screw
1 long screw (the bar)
2 decorative rings
Installing the New Strap
4. Reassemble in Reverse Order
-
Place the decorative rings back into position on each side of the new strap.
-
Slide the long screw bar through the strap and rings.
- Ensure to push the strap firmly against the watch case between the lugs while inserting the long screw.
-
Secure the attachment by carefully screwing in the short screw from the opposite side.
Make sure everything is aligned and tightened securely, but don’t over-tighten.
Final Check
Once installed, gently tug the strap to ensure it’s firmly attached. Your Wryst watch is now ready to wear with its new look.
